Get started
Set up the devices
XBee 868LP RF Modules User Guide
36
5. In the
Discover radio devices
dialog, select the serial ports where you want to look for devices
and click
Next
.
6. In the Set port parameters window, maintain the default values and click
Finish
.
As XCTU locates devices, they appear in the
Discovering radio modules
dialog box.
7. Click
Add selected devices
once the discovery process has finished.
You should see something like this in the
Radio Modules
section:
Configure the first two devices in Transparent mode
To transmit data wirelessly between your XBee devices, configure them to be in the same network.
Tip
To locate a device, select it in XCTU and click the
Read radio settings
button
. The Rx and Tx
LED lights on its development board blink green and yellow.
Set up the first XBee device (XBEE_A)
1. Select the first XBee device.
2. Click the
Load default firmware settings
button
.
Tip
In the following steps, type parameter letters in the Search box
to
quickly find a parameter.
3. Configure the following parameters:
ID:
2015
DH:
0013A200
