37
OUT1 and OUT2 Mode:
defines the status change of the relay output when the event managing this output
occurs.
Event:
defines the event that will manage the relay output: e.g. if you set the IN1 to 1 and the IN4 to 1, when
IN1 and IN4 change their status, the configured output will vary according to the mode set in OUTx
Mode.
Timeout (sec.) :
defines the duration that the output must keep with the new status.
Main Power ON:
enables the sending of a SMS message each time the Vega Video is turned on or the
power supply is re-established after a blackout. The SMS message will be sent to the phone numbers
inserted in the
SMS Number
item to be found in the GPRS configuration page. The item
Enabled
enables the sending of the SMS while
Disabled
disables it.
Message:
defines the text of the message sent if the SMS Main Power On item is enabled.
The text can be maximum 30 characters long. The default message is MAIN POWER ON.
Main Power OFF:
enables the sending of a SMS message in case of a main power supply lack. The SMS
message will be sent to the phone numbers inserted in the
SMS Number
item to be found in the
GPRS configuration page. The item
Enabled
enables the sending of the SMS while
Disabled
disables
it.
Message:
defines the text of the message sent if the SMS Main Power Off is enabled.
The text can be maximum 30 characters long. The default message is MAIN POWER OFF.
Alarm Area Full:
enables the sending of a SMS message when the area dedicated to the saving of images
– in the event of alarm detection – reaches the maximum limit. The SMS message will be sent to the
phone numbers inserted in the
SMS Number
item to be found in the GPRS configuration page. The
item
Enabled
enables the sending of the SMS while
Disabled
disables it.
Message:
defines the text of the message sent if the Alarm Area Full is enabled. The text can be maximum
30 characters long. The default message is ALARM AREA IS FULL!
NOTE: the sending of SMS messages is enabled only for the Vega Video GPRS.
