39
Live
The phone call is associated to an Internet connection request.
When you need to access the Vega Video GPRS remotely, you only need to
call the Vega Video GPRS phone number from your mobile phone. The
device reads the incoming phone number and compares it to the phone
numbers in the
Cli Enabled
configuration page. If the user is enabled, then
the Vega Video denies the call and immediately activates an Internet
connection via GPRS. Then it notifies the user requesting it with its IP
address, via a SMS message.
Alarm On Off
The phone call is associated to the camera Standby management.
The Standby function allows – with the Vega Video on - to enable or disable
the digital inputs and to perform the alarm detection.
For example, you may disable the Vega Video before entering home and
reactivate it when leaving it.
When the Vega Video GPRS is active, you only need to call the Vega Video
GPRS phone number from your mobile phone. The device reads the incoming
phone number and compares it to the phone numbers in the
Cli Enabled
configuration page. If the user is enabled, then the Vega Video denies the call.
From now on the device will ignore the status changes on the digital inputs
and you may, for example, enter home without receiving an alarm message
by the device.
When you go out again, to reactivate your Vega Video you just need to
behave in the same way: you will have to call the device that is going to detect
the phone number and deny the call again. This time, to make sure about
activation, you will receive a phone call by the Vega Video after a few
seconds: deny the phone call by pressing the call end button on your mobile
phone (usually the red hang-up button).
To sum up:
- to
disable
the digital inputs, call the Vega Video GPRS; this will deny the call
without calling back.
- to
enable
the digital inputs, call the device; this will deny the call and after a
few seconds it will call you back to confirm the operation.
Cli Enabled:
in these fields you must digit the phone numbers of the users who will be allowed to manage
the phone call. The phone number should be preceded by the international prefix (e.g.
+393351234567).
SMS To CLI:
SMS management to confirm the operation.
Disabled
The SMS message with the IP address following a
Live
or
Alarm Simulation
Internet connection request is sent to all phone numbers in the GPRS
configuration page.
Enabled
The SMS message with the IP address following a
Live
or
Alarm Simulation
Internet connection request is sent to the user who requested the connection
and called the Vega Wireless Camera GPRS.
WARNING: before calling the phone number of the SIM card in the Vega Video GPRS, check that your
mobile phone is enabled to transmit your phone number. If the Vega Video receives an
anonymous call (that is no phone number is displayed), it does not perform any operation and
only denies the call. Check with your phone company that the SIM card in the Vega Video
GPRS is enabled to receive voice phone calls. The SIM cards with a Machine To Machine
contract are not allowed to receive voice phone calls.
