17
Resetting the partial totalizer
To reset the partial totalizer, it is necessary to access the partial visualization mode
and then press the function key for about 3 seconds (or until all the digits are zero).
Configuration of operation mode:
The counter can be configured to count pulses or turns clockwise or anti-clockwise
(the denomination “clockwise” and “anti-clockwise” only serves to distinguish the
two tuning directions). To configure the counter, it is necessary to access the total
visualization mode and proceed as shown:
Sensors:
The sensors must connect the sensor's input to the counter's ground wire (switches,
optical couplers, buttons, relays, etc.).
Power characteristics:
Power
2 batteries AA (3Vcc)
5V (battery eliminator)
Battery life
1,5 year or over 3.000.000 cycles
(alcaline batteries, with sensors and open buttons)
Number of digits
6
Period of data retention
1 min 30 secs (to replace batteries without losing count)
Digits size
8 x 4 mm (height x width)
master
