20
Passage direction
PROG1 (pino 13)
PROG2 (pino 14)
Free in both directions
open
open
Controlled from left to right
GND
open
Controlled right to left
open
GND
Controlled on both sides
GND
GND
INFORMATION:
-
Side pictogram 1 and 2 refer to the devices located on each side of the
equipment.
- The cables of the optical sensors (CN11) and the electromagnets (CN10)
are provided alongside CATRAX Plus.
-
The cable of the box sensor (CN9) is provided alongside the collecting
box kit (optional)
INFORMATION:
:
PIC1 and PIC2 refer to the pictograms located on each
side of the equipment.
X
X
PIC1 (pino 15) PIC2 (pino 16) Pictogram 1 Pictogram 2
Open
Open
GND
GND
Open
GND
Open
GND
X
X
Particularly about the CN11 connector, pins 13 and 14:
can be
CATRAX Master
configured as follows to determine direction passage:
Pins 15 and 16, which control the side pictograms, must be configured thusly:
The following sections concern important aspects of
control board
CATRAX Master
configuration and connections.
6.7.1 Inputs
The input signals or passage clearance (HAB1 and HAB2) can be originated by a
relay contact, pushbutton contact, tension from 5 to 24 Vca/cc, from 110 to 220
Vca/cc. To enable passage through relay contact or pushbutton, make the
connection as shown below:
master
NO or NC contact
