26
The control board and monitoring that integrates the device is presented below.
The anti-panic system requires a power of 12Vcc 2A. Optionally, Digicon also
provides a switched-mode power supply (code 019.01.334).
To avoid overheating of the solenoid, the control board has an automatic routine that
reduces its voltage to 6Vcc two seconds after the turnstile is turned on. One
disassembled, the arm should be placed manually back into position.
6.8.1 ower connection
P
To disassemble the arm, it is necessary to cause a short-circuit between the GND and
LIB inputs, as shown below:
master
Connect to other turnstiles
as indicated above
NO key or relay contact to
disassemble the arm
