29
Connect the equipment’s AC power cables to the terminals indicated below:
Phase:
it must be connected to the gray terminal.
Neutral:
it must be connected to the blue terminal.
Ground:
must be connected to the green terminal.
Figure 27
AC power cords inpu
t
}
G
N
P
6.7 Selector switch
Many
dFlow
adjustments and settings are available in a practical and friendly way.
Through the selector switch, several functions can be activated, such as validation and
calibration of the overhead sensor, door centralization, switching between operational
status of entry and exit, and change of color of upper LED lights bar. To activate the
functions, the switch must be turned (clockwise) and the OK button (beside it) must be
pressed.
Functions:
M0:
Ÿ
Normal operation – rest position of selector switch (at any moment, you can put the
switch to position 0 and press OK and the
dFlow
will return to rest position;
M1:
Ÿ
Sensor's calibration validating: briefly press the OK button;
Ÿ
Sensor's calibration: press the OK button for 3s.
M2:
Ÿ
Calibration of doors' limit switch: press the OK button;
Ÿ
Doors' centralization: press the OK button again;
Ÿ
If only calibration is necessary, place the switch at position 0 and press OK again.
M3:
Ÿ
Switches among entry's operational status: Controlled, Free, and Closed. Press OK until
desired operating state is reached.
M4:
Ÿ
Switches among exit's operational status: Controlled, Free, and Closed, if the doors
mode allows it. Press OK until desired operating state is reached.
M5:
Ÿ
Alters the upper LED lights bar when idle, that is, when there is no user inside the
equipment. The colors are yellow, blue, orange, turquoise, white, purple, pink, olive,
and brown. Press OK until you reach the desired color.
M6:
Ÿ
Test mode for the upper LED lights bar: briefly press the OK button;
Ÿ
Test mode for the doors: press ok the button for 3s;
Ÿ
To deactivate the test mode, press the OK button for 3s; if you press the OK button
briefly, the
dFlow
will return to the LED lights bar test mode.
Summary of Contents for dflow
Page 1: ...1 Product Manual...
Page 40: ...40...
