7.
Control board
Turnstile Tx1500's control board was designed to meet most technologies of access
control terminals in the market. The controller have mechanical features and layout
perfectly suited for the Turnstile Tx1500's needs and it is one of the best options for
the equipment's operation.
The following images show the control board with its straps, connectors, and
dipswitch, as well as the location of the power supply and the control board.
The table below describes the functions of the control board's connectors:
6.
Power supply
This power supply was especially designed for the line CATRAX. Among the main
advantages of this optional item, is its adaptation capability to the voltage variations
often found in installation sites
–
the input voltage can vary between 100 and 240
V .
ac
The supply's speci
fi
c technical features, protections and dimensions were carefully
tested and approved in hostile temperature and environmental conditions, which
ensures the adequate power supply to the equipment's performance. Besides the
input and output voltages indicated in the image below, the supply has a short-
circuit and overheating protection.
INPUT:
100 A 240 Vac
OUTPUT:
Ground
Neutral
Phase
12V 5% / 3A
+-
GND
TIP:
The power supply can be mounted to the board's support hat
accompanies the Turnstile.
25
Torniquete
Tx1500
Cn1
Cn2
Ds1
Cn8
