18 Helvar 924 LCD TouchPanel: Installation and User Guide
Doc. 7860137,
issue 6, 2014-08-28
7.4 Editing Digidim Control Subdevice Properties (buttons, infrared,
analogue inputs and digital inputs)
1. From Main Menu select the following:
2.
to display the Controls menu.
3. Select the Control for which you want to edit the subdevice properties.
4. Select a button or input to edit.
5.
and then select a group to which this subdevice will belong.
6.
or
to toggle the input between analogue or linear mode (Analogue Input Unit 942 only).
7.
and then to set the Rising Threshold percentage (for Analogue Input Unit 942 only).
8.
and then to set the Falling Threshold percentage (for Analogue Input Unit 942 only).
9.
to modify the slider input (for Analogue Input Unit 942 only). See section 25.5.
7.
and then select a Group to which the control will belong.
8.
to enable or disable infrared.
9 , or and then select the type for each input (for input units only). You may change an input type from
Switch Edge , Switch Button , Analogue Edge , or Analogue Slider depending on the input unit selected.
10.
and then select a PIR mode (for Multisensor 312 only).
11.
to enable or disable the Constant Light feature (for Multisensor 312 only). When enabled, constant light scenes
become available ( ).
12.
to display the Advanced Settings menu. Choose from the following control-specific settings:
*
to lock or unlock the Control. Locking a Control prevents local scene stores and changes.
*
to set the Scene Store Delay time. Scene Store Delay determines the length of time a scene button must be
pressed before the scene is stored.
*
to enable or disable the infrared 2-button modifier.
*
to switch the infrared filter to accept only broadcast IR, or also to accept a selected IR
channel.
*
to select the scenes that will, when recalled, disable PIR (for Multisensor 312 only).
13.
to save the changes to Advanced Settings and to save the changes.
