21
Vision-64 User Guide
Issue 1.02
Copyright
©
2002-2004 Digflex Pty Ltd
6. Using the numeric keys, enter all the digits of the third
telephone number (if required).
You can change a single digit by scrolling the cursor left [
←
]
and right [
→
]. For special characters (eg. , = pause * or
# etc), use the [
↑
] and [
↓
] keys. To clear all text from the
cursor position to the right, press the [OFF] key.
7. Press [OK] to save and exit, or press [MENU] to cancel.
Comms > Commands >
Call Forward On Number
MENU 5-1-6
When you leave your premises, you no longer need to remember
to manually activate the Call Forward On feature via the telephone.
These addresses allow you to program the Call Forward On
sequence that the Vision control panel will automatically use when
you turn Area 1 ‘On’.
In Australia, a typical sequence of activating the Call-Forward On
– After Time (All Calls) is described below:
For other countries please substitute the appropriate commands after
consultaion with your telephone company.
1. *61 (To turn Call Forward On – After Time).
2. Telephone number that you want calls to go to (e.g.
0416123456).
3. *5# (End of Call Forward sequence after 5 seconds).
Therefore, you would program the above steps as follows:
*610416123456*5#.
1. Enter [MENU] + [5] + [1] + [6].
The keypad will display information for telephone number 1.
Call Forward On N001
Press
0-9 OK to SAVE
2. Using the numeric keys, enter all the digits of the call
forward on sequence.
You can change a single digit by scrolling the cursor left [
←
]
and right [
→
]. For special characters (eg. , = pause * or #
etc), use the [
↑
] and [
↓
] keys.
3. Press [OK] to save and exit, or press [MENU] to exit without
saving.
Comms > Commands >
Call Forward Off Number
MENU 5-1-7
When you enter your premises, you no longer need to remember
to manually disable the Call Forward feature via the telephone.
These addresses allow you to program the Call Forward Off
sequence that the Vision control panel will automatically use when
you turn Area 1 ‘Off’.
In Australia, a typical sequence of activating the Call Forward Off
feature is described below:
For other countries please substitute the appropriate commands after
consultaion with your telephone company.
1. #61 (To turn Auto-Forward After Time - Off).
2. # (End of Call-Forward sequence).
Therefore, you would program the above steps as follows:
#61#
1. Enter [MENU] + [5] + [1] + [7].
The keypad will display the current call-forward off sequence.
Call Forward Off N001
_
Press
0-9 OK to SAVE
2. Using the numeric keys, enter all the digits of the call
forward off sequence.
You can change a single digit by scrolling the cursor left [
←
]
and right [
→
]. For special characters (eg. , = pause, * or #
etc), use the [
↑
] and [
↓
] keys.
3. Press [OK] to save and exit, or press [MENU] to exit without
saving.
Comms > Registration >
Customer
MENU 5-5-0
Reserved
Comms > Periodic Test >
Send Test Report
MENU 5-9-0
This menu allows you to test the reporting functions of the Vision
control panel by manually sending a ‘Test’ report to the receiving
party (i.e. security company monitoring station, mobile telephone
etc).
1. Enter [MENU] + [5] + [9] + [0].
The keypad will prompt that it is in the process of sending a
test report.
Comms testing in
progress. Please wait..
To Go Back Press OK
