25
Vision-64 User Guide
Issue 1.02
Copyright
©
2002-2004 Digflex Pty Ltd
Table 5: Vision-64 Trouble Messages
Trouble Condition
Description
Mains Missing
The system has detected that the AC mains supply has failed or is disconnected. If there is not a general power outage
in your area then you should contact your security company.
Battery Low
The backup battery has failed the periodic test which the system performs on a regular basis. You should contact your
security company as the battery may need replacing.
Battery Missing
The system has detected that its backup battery has been disconnected.
Battery Reversed
The system has detected that backup battery has not been connected correctly.
You should contact your security company.
Voltage Low
The voltage reading the keypad has fallen below the minimum programmed by the security company.
Voltage High
The voltage reading at the keypad has increased above the maximum programmed by the security company.
RF Rxer Missing
The system has detected that the RF receiver is disconnected.
RF Rxer Tamper
The system has detected that the tamper circuit on the RF receiver is faulted.
RF Rxer Jammed
The system has registered a jamming fault from the RF receiver. This situation may preven certain parts of your system
from working correctly. You should contact your security company.
Comms Trouble R1
The system has failed to send reports to the primary report contact. You should contact your security company.
Comms Trouble R2
The system has failed to send reports to the secondary report contact.
You should contact your security company.
Comms Test Fail
The system has failed to send its periodic report to the monitoring station.
You should contact your security company.
Buss Trouble
The system has failed to communicate to a system device (e.g. keypad etc).
Default PIN Trbl
The system has detected that either the Installer PIN or User 1 PIN has not been changed from the factory default codes.
These codes should be changed immediately to prevent a security risk.
Date And Time
The system date and time needs to be set.
Cabinet Tamper
The system has detected that someone has tampered with its metal enclosure or that it has been forced open. Inspect
and contact your security company if necessary.
Siren Trouble
The system has detected that the external siren has failed or has been disconnected from the system.
Telco Line Trouble
The system has detected that its telephone line has been disconnected for a minimum of 30 seconds.
LAN Overload
The system has detected that the current load has exceeded the maximum LAN rating.
You should contact your security company.
Comm+ Overload
The system has detected that the current load has exceeded it’s maximum COMM+ rating.
You should contact your security company.
Accessory Overld
The system has detected that the current load has exceeded it’s maximum ACCS+ rating.
You should contact your security company.
Time For Service
The system displays this trouble condition to remind you that a service call is due.
Memory Fault
The system has detected an error with its internal memory. You should contact your security company.
Default Memory
The system memory has reset to factory default. You should contact your security company.
Service Mode
The security installer has entered service mode.
Phone In Use
The system is using the phone line.
