LX-MADI
User Manual
v1.0 October 2015
1 INFORMATION FOR THE USER
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions contained in this data sheet, may cause harmful interference to radio and television communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
●
reorient or relocate the receiving antenna
●
increase the separation between the equipment and the receiver
●
connect the equipment into an outlet on a circuit different from that of the receiver
●
consult the dealer or an experienced radio / television technician.
Note:
Connecting this device to peripheral devices that do not comply with CLASS B
requirements or using an unshielded
peripheral data cable could also result in
harmful interference to radio or television reception.
To ensure that the use of this product does not contribute to interference, it is necessary to use shielded I/O cables.
The user is cautioned that any changes or modifications not expressly approved by Digigram could void the user’s
authority to operate this equipment.
Warning:
Electrostatic discharge (ESD) can damage several components on the board.
To avoid such damage in handling the board, take the following precautions:
Bring the device and everything that contacts it to ground potential by providing
a conductive surface and discharge paths. As a minimum, observe these
precautions:
●
Disconnect all power and signal sources.
●
Place the device on a grounded conductive work surface.
●
Ground yourself via a grounding wrist strap or by holding a
grounded object.
●
Ground any tool that will contact the device.
2 IMPORTANT NOTICE
This card has been tested and found to comply with the following standards:
●
International: CISPR22 Class B.
●
Europe: EMC 89/336/CEE (1992) specifications.
●
United States: FCC RulesPart 15Class B (digital device).
2
