D i g i g r a m
10
Updating the VX driver under Windows 2000, XP, and
Windows Server 2003
•
Remove the driver as described above.
•
Run the installation program of the new driver, as described above.
Note:
If you have done an installation without selecting the Wave driver,
and want to install it now, it is necessary to remove the installed
(DirectSound) driver, and then re-install it.
HOW TO CHECK THE INSTALLATION
Once the driver and the cards are installed according to the procedure
described in this manual, you can verify that the card is properly installed and
works fine as follows:
Go to
<Start> <Programs> <Digigram>
and select Digigram
Control Center.
In the Digigram drivers window, select the General Information
tab.
In the Modules Information window the installed VX Kit modules
are displayed along with their versions.
In the Digigram drivers window, select the VX Setup tab for a list
oft he installed cards. Each card is represented by an icon.
Click on the Windows Multimedia properties button to open the
'Sound & Multimedia properties' window. Select the Audio tab.
The card devices are listed:
VX222-Mic Out #1 in Sound playback, preferred device.
This is a Wave device.
VX222-Mic In #1 in Sound recording, preferred device.
This is a Wave device.
VX222-Mic Audio Card (WDM) in both playback and recording,
preferred device. This is a DirectSound device.
In case the card is not displayed:
make sure that the card is correctly inserted in the PCI slot, and
screwed on the PC chassis.
if necessary, uninstall the VX Kit package as described above and re-
install it.
