VX881e
&
VX882e
User
Manual
INFORMATION
FOR
THE
USER
This device complies with part
15
of FCC rules. Operation is subject to the
following two conditions: (
1
) This device may not cause harmful interference,
and (
2
) This device must accept any interference received, including
interference
that
may
cause
undesired
operation.
This equipment has been tested and found to comply with the limits for a
CLASS B digital device, pursuant to Part
15
of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions contained in this data sheet, may cause harmful interference to
radio and television communications. However, there is no guarantee that
interference
will
not
occur
in
a
particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following
measures:
*
reorient
or
relocate
the
receiving
antenna
*
increase
the
separation
between
the
equipment
and
the
receiver
* connect the equipment into an outlet on a circuit different from that of the
receiver
*
consult
the
dealer
or
an
experienced
audio
television
technician.
Note
:
Connecting this device to peripheral devices that do not comply with
CLASS
B requirements or using an unshielded peripheral data cable could also
result
in harmful interference to radio or television reception. The user is
cautioned
that any changes or modifications not expressly approved
by
the
party
responsible
for compliance could void the user’s
authority
to
operate
this
equipment.
To
ensure
that the use of this product
does
not
contribute
to
interference,
it
is
necessary
to
use
shielded
I/O
cables.
5
Summary of Contents for VX881e
