RFID Interface
Bolt Mechanism
Shared Use Functionality
Product Guide
R F ID
CARD
Manager
Programming Instructions
3
Add Manager Keys and RFID Credentials
Manager Keys can be programmed to the locks at any time.
Go to a lock requiring additional
Manager Keys.
Press and hold
`
for 5 seconds (a
two-tone beep will be heard after 5
seconds) then release.
The LED will turn on.
While the LED is on, insert the
Programming Key.
A two-tone beep will be heard.
Insert each additional Manager
Key or Manager RFID Credential
one at a time.
A two-tone beep will be heard for
each Manager Key or Manager
RFID Credential programmed.
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Repeat above steps for each lock
or follow instructions to Express
Register Manager Credentials to
program the same Manager Keys
to multiple locks.
Replace Keys
Replacement keys must be purchased and programmed to the locks to prevent the lost/stolen keys from operating a lock.
To replace the Programming Key:
Note the order or serial number (found on the lock’s rear unit).
Contact Digilock Support to purchase a replacement Programming Key.
To replace the Manager Keys:
Collect all remaining Manager Keys.
Go to any lock operated by the lost/stolen manager credentials. Press
and hold
`
for 5 seconds (a two-tone beep will be heard after 5 seconds)
then release.
The LED will turn on.
While the LED is on, insert the Programming Key.
A two-tone beep will be heard and the LED will remain on.
Insert the Programming Key again.
Three sets of two-tone beeps will be heard and the LED will turn off. All
previously programmed Manager Keys and Manager RFID Credential
are erased.
Follow instructions to Add Manager Keys and RFID Credentials to
program the intended Manager Keys to the locks.
1
2
4
3
1
1a
1b
2
2a
2b
