1
) Connect the Sub-D plug on the Video Web Server with the COM/NO ports of the
Sensor.
2
) Set the “Mail setting ” item in the system configure.
NOTE 1
: You can get all the data from the ISP ( Internet Service Provider) company or by
mailing to the server supplier
(POP3/SMTP server)
.
NOTE 2
: You should set the mail list when the alarm is triggered.
NOTE 3
: When the alarm is triggered, you can find “
” message showed on the screen.
T
he AP will start recording automatically
and you can get the email with the
snapshot image in your mailbox.
APPENDIX #2 – SENDING E-MAIL
-36-
Video Web Server
N.O. Sensor
Pin 5
Pin 4,7, 8 or 9
GND
ALARM INPUT
A normally open contact/sensor can be connected where
Pin 5 is Ground and Pin 4, 7, 8 and 9 is the Alarm Input
digimerge.eng
digimerge.eng
dliu@digimerge. c o m
