Digimerge DBD14, Instruction Manual

-5-

INSTALLATION. INDOOR DOME

1) Remove camera base by twisting it 

clockwise to lign up the arrows on 

the side of the camera housing (see 

FIG 1). Remove the camera base by 

pulling it away from the camera.

Note:   Dome cover is attached to a cord 

to stop falling off.

FIG 1

FIG 2

2) Remove the dome cover by 

inserting a flat screw driver into the 

slot next to the dome cover release 
clip (See FIG 2) and pressing down 
on the screwdriver

Note:  If your installation requires 

cable to be from side of dome, 

remove the cut away portion of 

the base.

3) Attach base to surface using drill 

template as a guide.

With base attached, re-fit the body of 

the camera onto the base using the 

arrows as a guide (see FIG 1) and 

turning the camera clockwise.

4)  Adjust camera viewing angle and 

secure into place by tightening 

thumb screws.

Re-attach the camera cover, using the 

dome cover release clip as a guide, 

until it snaps into place. 

Note:   Lens adjustment levers are by 

default in the locked position. 

Turn counter clockwise to 

unlock. Tighten levers to 

secure lens setting.

Camera Body

Open     Close

1

2

3

4

Ceiling

Dome base

Cut Away for
Cable side exit

Open

Open