46
B (unlocked)
A (locked)
Step 6: Secure the HDD in the Cartridge Casing.
Position the HDD into place and secure it using the six screws supplied.
Step 7: Slide the top Cover over the Cartridge Casing.
Slide the Cover forward over the Cartridge Case. Ensure it is secured in place over the release latch.
Reinsert the Cartridge Casing into the DGN216
Step 8: Lock the Cartridge.
To Lock the cabinet, turn the key clockwise to Position A.
To unlock the cabinet, turn the key counter-clockwise to Position B.
NOTE
: The DGR216 will not function if the key is not in the locked position.
1. If two HDD’s are installed, the bottom one should be set to “Master “, and the top one to “Slave”.
2. This product does not support hot swap. Please power off the unit before removing HDD.
3. Approved models and manufactures of HDD are listed in Appendix #6 and have been tested and proven compatible with
this DVR.
4. Please remove hard disk drive ONLY after power is shut off for more than 60 seconds. This would protect and extend the
operating life of the hard disk drive.
5. HDD should be set up by selecting HDD Jumper.
