PAN / TILT ZOOM:
The TFT monitor is equipped with a built-in Pan/Tilt Zoom feature, which is only available when
used in conjunction with a compatible Pan/Tilt Zoom (Zoom optional) Dome camera.
The Pan/Tilt Zoom feature supports “Pelco D” protocol, and operates via the RS-485 connection
For a compatible camera on Channel 1. To access and operate the PTZ feature, follow these
instructions:
1)
Connect a compatible Pan/Tilt Zoom Dome camera to Channel 1.
2)
Connect the RS-485 control wires to the terminals on the rear of the unit.
3)
Go to the SYSTEM submenu and set the PAN/TILT(CH1) option to “Y”,
4)
You will see a contracted screen with a blue border. Use the Arrow keys to sideways,
and ENTER to select whether to MOVE, ZOOM, or FOCUS the camera.
5)
Enter Pan/Tilt Zoom mode by holding the PAN/TILT key on the monitor for 3 seconds, or
press the Pan/Tilt button on the remote control;
6)
If you have selected MOVE, you can use all four arrow keys to Pan and Tilt in all
directions. If you selected ZOOM or FOCUS, use the
▲▼
arrow keys to Zoom / Focus
IN / OUT.
7)
Select and press ENTER on the EXIT option to escape Pan/Tilt mode.
Note: the system automatically exits Pan/Tilt mode after 20 seconds of inactivity.
Refer to the diagram below for an illustration of Pan/Tilt Zoom mode.
[CH1 PAN/TILT MODE]
MOVE
ZOOM
FOCUS
EXIT
-11-
