USER’S MANUAL
64
MENU SETUP
6.4.8 RELAY OUTPUT
At the EVENT menu,
Move the cursor to the “RELAY OUTPUT” using the , buttons.
Press the ENTER button when the cursor is on the “RELAY OUTPUT” and the following
screen appears.
Move the cursor using the , , , buttons and set up the value using the (-), (+) buttons.
Press the button to see the next page.
To exit this screen, press the “ESC” button.
NOTE
- It is possible to set the RELAY OUTPUT of each channel in the type of event.
- Relay output is from 1 to 4 and it is possible to set the period of the relay output.
<RELAY 4 SELECT>
There are POWER, USER, NOT USED and HDD ERROR.
z
POWER: The relay is working when power is off.
z
USER: User can operate the relay manually.
Press the “FUNCTION” button to operate RELAY 4 manually.
NC
→
NO: And then press the (+) button.
NO
→
NC: And then press the (-) button.
Press the “FUNCTION” button again if you want to exit this mode.
(You can also use this function through network viewer. Please refer to page 87.)
