digiO2 ECG-10X, User Manual

Power on / off

Press             to turn on / off Cardio Care. 
After the welcome message, You will 
enter main menu automatically, where 
you can proceed on taking measurement, 
checking historical record or adjusting 
setting.

Measurement

A.  Make sure to be in a relaxed condition. 

The ideal posture of being seated 
comfortably with your back straight is 
suggested. However, measurement 
can still be made while you are 
standing, lying down or in other 
comfortable positions.

B. Use your right hand to hold the unit 

properly with your fingers gently 
pressed on the side electrodes. Please 
refer to the figure. 

C. Press     and it will start measuring with a beep sound after 5 seconds. 

Place the unit with the back end electrode against the spot slightly 
below your chest,  The measurement will stop after 30 seconds of 
recording automatically and is accompanied with a beep sound,The 
heart rate will be shown on the page and press        .

D. The unit will ask automatically if 

you want to upload the record to 
server, press       to upload or          to 
skip.

E. After selection, it will go into the page of showing historical record list 

immediately. More details about the record reading will be shown in the 
“Historical Record” section.

<NOTE>
Please use ONLY your right hand to take the measurement

Operating Instructions

04

05

About 2 inches

below your left nipple

< main menu >

Press button        and start to 
measurement.

After press         the device will 
show the loading page, and 
then start to measurement.