Operating the unit
1
2
Caution
When processing the smallest documents (minimum size for documents is
2.9 in. x 2.0 in.), the endorser top print position is too high to endorse properly.
Check that the endorser print position is correct when feeding small
documents.
3.
Do not raise the endorser above the top print position. If you do, make sure the
endorser cable is pushed back through the slot and underneath the base plate
when you move the endorser back to a print position. There should be no loop
or bulge in the cable above the base plate.
Endorse cable
Endorse Top
print position
Solt in Baseplate
Document Preparation
It is important to properly prepare documents for processing. Otherwise,
unit performance
2-4
82275345-003
