Installation & Operations Guide - SmartSource Expert Micro Elite
June 2019
8227 6059-001
Page 19 of 30
If the bottom edge is not aligned, the unit may not be able to read the code line, and document images may be skewed.
Processing documents
When a document is placed in the feed area, the unit may begin processing automatically, or you may need to press the
start-stop button briefly to start processing. How this works depends on your document processing software application.
The document will be fed singly from the feed area and stopped in the output area. To continue processing, place another
document in the feed area. Depending upon your application, the unit may resume processing automatically, or you may
need to press the start-stop button again to resume.
Removing items from output area
Pull document out of the output as shown. The document will stop in the last pinch of the drive.
Stopped-document conditions
If the unit stops with a document in the track (between the feeder input and the output area), first refer to the application to
determine the cause of the stoppage. Many stoppages are not the result of any problem with the unit, but may be caused
Pull out document in direction shown
