‑4‑
The PL-HD210 is factory set for use as the PL's Slave drive, however, if the
user desires to change this setting so that the PL-HD210 can be used as the
PL's Master drive, follow the procedures given below.
<PL-HD210 Front Face Connector>
Slave Setting
(for use as Slave)
Master Setting
(for use as Master)
Jumper Plug
When using the PL-HD210 as
a Master, be sure to remove
the jumper plug, like shown
in the left side figure.
• All of Digital's PL-X900 Series units have a built-in hard
disk unit. These units, when shipped, are all set as the PL's
Master. When an additional HDD unit (PL-HD210) is used,be
sure to set this unit's the jumper plug to Slave.
• Except for the jumper plug shown here, do NOT use any
other short plugs with the PL-HD210, since it can cause a
malfunction or damage the unit.
2
Hard Disk Unit Settings
!!!!!
Important
