Chapter 4 – Transfer Screen Data
4-2
GLC2300 Series User Manual
Transfer the logic program data from your PC via the Logic Program Development
Software.
For details about the Logic Program Development Software, refer to
the
Pro-Control Editor Operation Manual
(included in the
GP-PRO/PB III C-Package).
Transferring Data to a New GLC
Connect the GLC to your PC via the data transfer cable, and then turn the GLC ON.
The Initial Start Mode screen will appear on the GLC and you can transfer logic pro-
gram data from your PC to the GLC. The screen will change to the Transfer screen
automatically.
During data transfer, the
SETUP TRANSFE
R and
NOW TRANSFERRING – PLEASE
WAIT
messages appear. When these messages disappear, the screen data transfer is
completed.
You can cancel data transfer at any time using your GLC screen creation software.
When the screen data transfer is completed, if you do not need to set up the GLC, the
screen designated in
INITIAL SETTINGS | SCREEN SETUP | INITIAL SCREEN
FILE NO.
appears, and the GLC screen changes to operation (RUN) mode.
Completing Data Transfer Using GLC Setup
*1
When transferring screen data from the GLC screen creation software, the screen
automatically switches to
SCREEN DATA TRANSFER.
If the screen does not switch to
SCREEN DATA TRANSFER,
select
SCREEN DATA
TRANSFER
mode.
1.
To “Set up the GLC” means to download both the system program and the
user-specified protocol program from the GLC screen creation software to the
GLC unit.
