Chapter 4 – Transfer Screen Data
4-4
GLC2300 Series User Manual
You can now transfer data from your PC’s screen creation software.
Refer to the
GP-PRO/PB III for Windows Operation Manual
(in-
cluded with the GP-PRO/PB III C-Package).
You can also transfer your logic program data from your PC to the GLC via the Logic
Program Development Software.
For details about the Logic Program Development Software, refer to
the
GP-PRO/PB III for Windows Operation Manual
(included in
the GP-PRO/PB III C-Package).
Setting Up the IP Address Automatically
It is not necessary to select Ethernet Settings on the Initial Start Mode screen. When the
options for Ethernet Settings are not specified, they are set automatically.
If you choose to set the GLC unit’s IP address automatically, specify the IP address of
your PC in the range of “10.255.255.1” to “10.255.255.254” and the subnet mask as
“255.0.0.0.”
Transfer data to the GLC using the screen creation software package.
Refer to the
GP-PRO/PB III for Windows Operation Manual
(in-
cluded in the GP-PRO/PB III C-Package).
When Data Transfer Using the GLC Setup
*1
is Completed
When you transfer screen creation software data from your PC to the GLC while the
GLC is in RUN mode, the screen will change automatically to “Ethernet Mode.” If it
does not, you will need to manually change the GLC screen to Ethernet Mode, via the
following screen.
