Chapter 4 – Transfer Screen Data
4-6
GLC2300 Series User Manual
4.3
CF Memory Loader Tool
The GLC unit allows you to transfer screen data between your PC and the GLC and to
upload internal GLC data to its CF Card using the CF Memory Loader Tool.
•
You need to transfer the CF Memory Loader Tool to the
CF Card prior to using the CF Memory Loader Tool.
Refer to the
GP-PRO/PB III for Windows Opera-
tion Manual
(included in the GP-PRO/PB III C-
Package).
•
The combination of the CF Memory Loader Tool and
Backup Data often requires at least 8MB of CF Card
memory. As a result, Digital recommends you use its
CF Card “GP077-CF20 (16MB)” or “GP077-CF30
(32MB).”
Starting the CF Memory Loader Tool
There are two methods for starting this program via the CF Card.
1. Menu Bar: Using the GLC Unit’s [CF BOOT] Menu
Insert the CF Card with the CF Memory Loader Tool saved into the GLC and touch
the OFFLINE menu screen’s
CF BOOT
selection. The GLC will be reset, and after
it restarts, the CF card’s CF Memory Loader Tool will start.
For information about displaying the menu bar, see
6.4.3 – “
SET
UP TOUCH PANEL
.”
2. GLC Dip Switches: Forced Start via GLC Dip Switches
You can also use the Dip Switches on the rear of the GLC, next to the CF Card Slot.
If you turn ON (raise) Dip Switch No. 1 and then connect the GLC unit’s power
cord, the CF Memory Loader Tool will automatically start.
