4
4-10
Setting up the printer
APPLETALK ZONE
This option appears only if
ENABLE APPLETALK
is set to
YES
and your network is
divided into zones. Scroll through the list to select the AppleTalk zone in which
you want the Colorwriter to appear. If you do not enter a zone, the Colorwriter is
assigned to the default AppleTalk zone.
If the Colorwriter is set up by allowing it to reach
READY
using default settings,
AppleTalk is enabled and a default AppleTalk zone is selected. However, the name
of this zone does not appear on the configuration page. To see the zone on the
configuration page, run Network Setup in the printer control panel, select the
AppleTalk zone, and save changes. After the printer settings are updated, the
configuration page will list the selected AppleTalk zone.
N
OTE
:
Before you complete the following selections, you must first set up the
Novell file server.
ENABLE IPX
YES/NO [NO]
Select
YES
if you have an IPX (Novell) network connected to the Colorwriter.
Note that you can enable AppleTalk, TCP/IP, and IPX (Novell) communication
simultaneously.
IPX FRAME TYPE
ETHERNET 802.2/ETHERNET 802.3/ETHERNET II [ETHERNET 802.2]
Select the Ethernet frame type used for communication between your NetWare
file server and the Colorwriter LSR 2000
+
.
IPX SETTING
VIEW/CHANGE [VIEW]
Select
VIEW
to see a list of NetWare File Servers that are currently connected to the
Colorwriter LSR 2000
+
. Select
CHANGE
if you wish to change the configuration of
a file server that is already connected.
N
OTE
:
If you select
CHANGE
, you must reselect all the NetWare File Servers and
reconnect them to the Colorwriter.
