4
4-18
Using the density control panel
Density adjustments from the density control panel
Density adjustments made from the density control panel are similar to manual
overrides that are applied just before printing. Therefore, these adjustments do not
enter into the automatic calibration that occurs during Colorwriter engine warm-
up.
Obtaining consistent results when you use CRDs requires that you use a
calibrated printer. We recommend setting the density control panel to the neutral
(center) position before you calibrate the Colorwriter with the Fiery Print
Calibrator.
ENTER
After you select a new density for one of the color selection
indicators (M, C, Y, Bk), press this button to save the new density
for the selected color indicator.
TEST PRINT
Prints a built in test pattern (solid color, solid white, gradation,
horizontal lines, vertical lines, or grid). Use the test print to check
the results of a density change.
