Loop
Option 19, Loop, allows you to perform connection testing to other devices on the
network. When you choose this option, the following appears:
What type of loopback do you wish to perform?
[1] ISO 802.2 XID Poll
[2] ISO 802.2 XID Loopback
[3] MOP V3 Loopback
[4] MOP V4 Loopback
Enter the type of loopback:
Enter the MAC address:
Depending on the type of loopback selected, the following may appear:
Enter the size of the test pattern <10>:
The test pattern size is the number of bytes which will be used in the loopback
test packet. The size can range from 1 to 1500.
For loopback types [3] and [4], the following also appears:
Enter the number of loops <1>:
Entering a number larger than 1 will result in being prompted for that number
of MAC addresses through which the loopback will be performed. The first MAC
address entered will be the first destination of the loop test packet. The test
packet will then be sent to the next MAC address and so on, until all MAC
address have been utilized. The test packet is then sent back to the originating
MAC address.
Show Counters
Option 20, Show Counters, allows you to view the DECagent 90 MOP counters.
When you choose this option, the following appears:
Enter the MAC address <xx-xx-xx-xx-xx-xx>:
Where <xx-xx-xx-xx-xx-xx> is the MAC address of either the DECagent 90 or the
last device for which counters were requested.
The acceptable formats are as follows:
uu-vv-ww-xx-yy-zz
uu:vv:ww:xx:yy:zz
uuvvwwxxyyzz
4–18 DECagent 90 Management
Summary of Contents for DECagent 90
