Installation 3-22
SYSTEM PARAMETER SET-UP
If it is necessary to change a configuration parameter, the procedure is as follows:
•
With the PC and the aid of an ASCII based word processor or a file editor,
create a file "XXXX" to write the parameters and descriptions that you want
to enter.
-When creating the configuration file pay attention to:
- use a new line for each parameter with its relevant description separate each
parameter from its description by a blank, a tabulation or an equal sign (=)
- the last line of the file must be "END" followed by a return with a line feed.
- To transmit the parameters to the printer:
- Switch on the machine keeping the INSTALL CARTRIDGE and
PORTRAIT-LANDSCAPE keys pressed until the initialization is completed.
- Send the parameters configuration file from the PC to the printer with the
command: copy "XXXX" prn
•
The printer will configure according to the parameters received from the PC.
Run the print test to verify the machine configuration.
Summary of Contents for DECcolorwriter 520ic
