6.4 DEClaser 1100 Printer Functional FIP
Table 6–4 (Cont.) DEClaser 1100 Printer Functional Messages
Number
Message
Description and Action
25 VECTOR REJ
Vector graphics commands from the host system cannot be
used because the printer is not in full paint mode. You have
two possible actions:
•
Press
Error Skip
, then
On Line
to continue printing.
Subsequent vector graphics commands are treated as
text and printed.
•
Stop sending data from the host, select the paint = full
value from the initial setup menu, then send the data
from the host again.
Note:
Vector graphics commands cause the printer to fill in
closed areas of circles, ellipses, and other shapes.
26 MEMORY FULL
The work memory used by the video control board has
overflowed and the current operation cannot be done. If this
happens frequently, the customer can increase the available
memory by installing an optional RAM expansion board.
Press
Error Skip
, then
On Line
to continue receiving data
from the host. The offending operation is ignored.
27–39
Not used.
40 LINE ERROR
The printer detects errors in the serial data received from
the host. The printer stops printing before the offending
page and displays the error message.
Do the following:
1.
Press
Error Skip
, then
On Line
to continue receiving
data.
2.
Inspect the data cable and connectors between the host
and printer and make sure the printer interface settings
match the settings of the host.
41 PRINT CHECK
A soft error occurred that can cause a print defect. Remove
and discard the top sheet from the stack. Then press
Error Skip
to continue printing and to reprint the discarded
sheet.
Troubleshooting:
If the problem occurs frequently, use
the troubleshooting procedure listed under 51 SERVICE in
Table 6–5.
Control Panel Messages FIPs 6–15
