10
Removal and Replacement Procedures
and RSL
This chapter contains the recommended spares list (RSL) and the removal and
replacement procedures for the field replaceable units (FRUs) of the DEClaser
1100 series printer. To remove an FRU, you find the procedure and then follow
the steps. To replace an FRU, you reverse the procedure, unless otherwise
noted.
The removal of most FRUs requires the removal of other components. For that
reason, a procedural step can refer you to another procedure. For example, to
remove the DC control board, you must perform the procedure to remove the
video control unit (VCU) and the upper and side covers. You should always
remove and replace the components in the order shown in the procedures.
Warning:
Before you disassemble the DEClaser 1100 printer, make sure the
power switch is off and the ac line cord is disconnected from the rear of the
printer.
If you must operate a disassembled printer, power the printer on, do the
required task, then turn the power off, and pull the plug.
Use of controls or adjustment procedures other than those specified in this
manual may result in hazardous laser light exposure to yourself or to other
persons in the room. The safety information presented in Safety Warnings only
applies while the scanner cover is fully installed.
Before servicing the optical components, you must have attended the training
specified in Section D.1.
Removal and Replacement Procedures and RSL 10–1
