10.5 Front (Multipurpose) Tray
10.5 Front (Multipurpose) Tray
Use the following procedure to remove and replace the front tray from the
front door of the DEClaser 1100 printer. The front tray is also referred to as
the multipurpose tray.
1. Remove the paper feeder unit, if installed, as shown in Section 10.4.
2. Move the printer so the tray is hanging over the edge of the desk.
3. Press each side, as shown, slightly bending the tray, until the hooks
disengage from the door.
4. Drop the tray down until the hinge pins freely separate from the door.
006047s
Removal and Replacement Procedures and RSL 10–7
