10.8 Low-Voltage Power Supply Assembly (LVPSA)
10.8 Low-Voltage Power Supply Assembly (LVPSA)
The LVPSA consists of the ac input, low-voltage power supplies, and the
high-current controller for the heater in the fixing unit.
Use the following procedure to remove and replace the low-voltage power
supply assembly (LVPSA):
Caution:
Use the standard antistatic equipment and procedures when you
handle this sensitive electronic component.
1. Remove the following components:
a. Upper cover, as shown in Section 10.2
b. Right and left side covers, as shown in Section 10.3
c. VCU, as shown in Section 10.20
2. Remove the four screws that hold the end plate to the printer chassis.
3. Remove the end plate.
4. Remove the screw that holds the LVPSA to the side of the baseplate.
006057s
Removal and Replacement Procedures and RSL 10–17
