10.9 Stepping (Main) Motor
10.9 Stepping (Main) Motor
Use the following procedure to remove and replace the stepping motor:
Caution:
Use the standard antistatic equipment and procedures when you
handle this sensitive electronic component.
1. Remove the following components:
a. Upper cover, as shown in Section 10.2
b. Right and left side covers, as shown in Section 10.3
c. VCU, as shown in Section 10.20
d. DCU, as shown in Section 10.19
2. Remove the two screws that hold the flange of the stepping motor to the
plastic bulkhead.
3. Remove the two wire harnesses from the molded restraints.
4. Remove the stepping motor.
006061s
Removal and Replacement Procedures and RSL 10–21
