10.16 Drive Assembly
10.16 Drive Assembly
The drive assembly transfers mechanical power from the motor to all
mechanical components of the printer.
Use the following procedure to remove and replace the drive assembly:
Caution:
Make sure you do not overtighten the screws that screw directly into
the plastic bulkhead.
1. Remove the following components:
a. EP-L cartridge, as shown in Section 10.13
b. Upper cover, as shown in Section 10.2
c. Right and left side covers, as shown in Section 10.3
2. Using needlenose pliers, pry out the center pin from the lower cable
restraint.
3. Remove the wires from the restraint.
006079s.
Removal and Replacement Procedures and RSL 10–43
