10.17 Density Adjustment Board
10.17 Density Adjustment Board
Use the following procedure to remove and replace the density adjustment
board:
Caution:
Use the standard antistatic equipment and procedures when you
handle this sensitive electronic component.
1. Remove the following components:
a. EP-L cartridge, as shown in Section 10.13
b. Upper cover, as shown in Section 10.2
c. VCU, as shown in Section 10.20
2. Unplug the 9-pin J215 connector
from the DC control board.
3. Unclip the wire harness clips
.
4. Remove the wire from the clips.
006082s
10–46 Removal and Replacement Procedures and RSL
