10.20 Video Control Unit (VCU)
Use the following procedure to remove and replace the video control unit
(VCU):
Caution:
Use the standard antistatic equipment and procedures when you
handle this sensitive electronic component.
1. Remove the following components:
a. Upper cover, as shown in Section 10.2
b. Right and left side covers, as shown in Section 10.3
c. Interface unit, as shown in Section 10.18. Do not disassemble the
interface assembly.
2. Unplug the 4-pin connector from the VCU.
3. Remove the two screws that hold the metal shield of the VCU to the top of
the printer.
006093s
Removal and Replacement Procedures and RSL 10–57
