10.24 Paper Exit and Door/EP-L Sensor
10.24 Paper Exit and Door/EP-L Sensor
Use the following procedure to remove and replace the bracket that holds the
paper exit and door/EP-L sensor from the DEClaser 1100 printer:
Caution:
Use the standard antistatic equipment and procedures when you
handle this sensitive electronic component.
1. Remove the EP-L cartridge, as shown in Section 10.13.
2. Remove the upper cover, as shown in Section 10.2.
3. Remove the two screws that hold the sensor bracket to the plastic
bulkhead.
4. Lift the sensor bracket and unplug both 3-pin connectors from the door and
paper exit sensors.
5. Unsnap the plastic sensor clips to remove the sensor from the bracket.
006108s.
Removal and Replacement Procedures and RSL 10–73
