B.2 Labels
B.2 Labels
A label consists of a face sheet, an adhesive sheet, and a carrier sheet. The
face sheet (or printing surface) is usually composed of photocopying paper and
should meet the same specifications for paper, as described in Table B–1. The
carrier sheet and adhesive used for the labels must also be able to meet the
heat tolerance specification of 150°C (302°F) for at least 0.1 second.
Do not expose the adhesive on the labels. Doing so could cause damage to the
printer. An easy way to test for adhesive that may be exposed is to press a
plain piece of paper on top of the sheet of labels. If the paper does not stick to
the labels, they are acceptable to use.
Special Considerations When Printing on Labels
Observe the following considerations when printing on labels:
• Feed labels from the paper tray.
• Be sure that the carrier sheet is not exposed.
• Be sure that no adhesive is exposed.
• Use the front faceup stacking tray.
B.3 Operating Specifications
This section contains the operating and interface specifications for the
DEClaser 1100 printers.
Type:
Desktop page printer
Printing Method:
Electrophotographic, using laser beam scanning
Resolution:
300 dpi
Printing Speed:
4 pages/minute maximum using A4 or
letter-size paper from the cassette
Warm-Up Time:
Less than one minute at 20°C (68°F)
Paper Tray:
Approximate capacity is 50 sheets of paper, labels,
or transparencies. A maximum of five envelopes
can be loaded in the paper tray.
Optional Paper Cassettes:
Approximate capacity is 250 sheets
Letter (8
1
2
in x 11 in)
A4 (210 mm x 297 mm)
Executive (7
1
4
in x 10
1
2
in)
Legal (8
1
2
in x 14 in)
Top Output Tray Capacity:
50 sheets (facedown stacking)
DEClaser 1100 Series Printers Specifications B–5
