4.5 DEClaser 1100 Printer Engine Test Print
4.5 DEClaser 1100 Printer Engine Test Print
Figure 4–4 is an example of the Engine Test print.
Figure 1–3 shows the location of the TEST PRINT button. Use a pencil or
other suitable tool to press it and the printer will respond as follows:
1. If the printer is on line and printing, the current job finishes printing.
2. The On Line indicator goes off.
3. The orange Alarm indicator lights.
4. The 15 ENGINE TEST message is displayed.
5. One copy of the test pattern is printed.
6. After printing, the printer returns to the offline Ready mode.
The Engine Test print is used for the following purposes:
• To check toner dispersion and line weight.
• To verify the condition of the print engine if the video control board, control
panel, or interface board are not installed.
The white area of the Engine Test print should be free of toner or smudges,
and the lines must print cleanly across the entire page with no faded areas. If
the print quality is poor, refer to Section 8.1.
4–8 DEClaser 1100 Printer Test Prints
