5.3 Transparency Specifications
Table 5–3 and Table 5–4 contain information on the sizes and specifications
of transparencies that can be used with the DEClaser 1100 printer.
Table 5–3: Transparency Sizes
Transparency Size
Dimensions
A4
210 mm x 297 mm
Letter
8 ½ in. x 11 in.
Table 5–4: Transparency Specifications
Category
Specification
Transparency weight:
front output tray only
135 g/m
2
to 150 g/m
2
basis weight
Thickness
0.095 mm to 0.115 mm
Heat tolerance
150°C (302°F) for 0.1 second
5.3.1 Special Considerations When Printing on
Transparencies
Observe the following requirements when printing on transparencies:
•
Transparencies are usually fed from the paper tray.
If you are
feeding transparencies from a cassette, be sure they are high-quality
transparencies and meet the specifications listed in Table 5–4.
•
Fan the transparencies before loading them to prevent jams.
•
Use the front output (faceup) tray only.
•
Remove transparencies from the output tray as each one is printed to
prevent them from sticking to each other.
NOTE:
See Appendix B for acceptable transparencies available from Digital.
5–8
Operator’s Guide
Summary of Contents for DEClaser 1100 Series
