6.4 Software Error Messages
You can correct many software errors by adding additional memory,
reassigning memory, or by selecting the proper interface parameter.
Table 6–4 describes the corrective action to take when a software error
occurs.
Table 6–4: Software Error Messages
Message
Meaning
Corrective Action
20 PAGE FULL
The page buffer is over-
flowing with data.
Clear fonts from memory after each
job.
Assign one or two full-page bitmap
areas in memory to handle the complex
data (Section 4.5.5.3).
Add additional RAM.
21 COMPLEX DATA
There is complex
print data that the
printer cannot handle.
Assign one or two full-page bitmap
areas in memory to handle the complex
data (Section 4.5.5.3).
22 LINE ERROR
The receiving buffer is
overflowing with data.
Enable a handshaking protocol to
regulate data flow (see Section 4.5.6.4,
Section 4.5.6.5, and Section 4.5.6.6).
Ensure that the host, the printer, and
any other devices that are connected
(such as printservers) all have the
same type of handshaking protocol
enabled.
23 MEMORY FULL
Memory cannot accept
additional downline load-
ing of fonts into memory.
Clear fonts from memory after each
job.
Reallocate less bitmap page memory
space (Section 4.5.5.3).
Add additional RAM.
24 FULLPAINT REJ
Full paint mode is not
allowed due to lack of
memory space.
Clear fonts from memory after each
job.
Add additional RAM.
Page format size does not
match specified memory
reservation.
Change paper format size (see Section 2.5)
or specify matching memory reserva-
tion (see Table 4–12).
6–6
Operator’s Guide
Summary of Contents for DEClaser 1100 Series
