2.4.1 Loading the Paper Tray
The loading procedure is the same whether you are adding paper, labels, or
transparencies to the paper tray. If you are adding envelopes to the paper
tray, see Section 2.6.1 for instructions.
NOTE:
Forms, envelopes, and letterhead paper must be loaded facedown
into the paper tray to print on the correct side. The front output tray must be
used for printing on envelopes, labels, or transparencies (see Section 2.7.2).
If you are changing the paper size, you must also change the page format
size (printing area) to match the new paper size.
When changing the
page format size, you need to reset the printer to invoke the new size.
See Section 2.5 for information about using
Feeder Select
to change the paper
format size.
Add paper to the paper tray using the following procedure.
1.
Be sure the printer is not printing and that the display reads 00 READY
(or 11 TRAY PAPER xx) before adding paper to the tray.
2.
Slide the adjustable paper feed guide to the left if you are changing the
paper size.
MLO-005965...Actual height is 21.5 picas.
Operating Information
2–7
Summary of Contents for DEClaser 1100 Series
