2.6 Printing on Envelopes
Envelopes have the same setup requirements as all other media. Since
you print addresses in a particular area on envelopes, you must give the
printer the proper print coordinates to print the addresses. Normally the
setup requirements for printing envelopes are defined by the application
program you are using. Consult your application program documentation
for details about its envelope printing feature.
If your application program does not have an envelope printing feature, you
need to set up your address files using commands that instruct the printer
to print in the correct location on the envelope. Appendix A contains a
listing of DEClaser 1100 commands and programming information for the
experienced programmer. For detailed programming information necessary
to set up your address files, see the Digital ANSI-Compliant Printing
Protocol Level 3 Programming Reference Manual and the Digital ANSI-
Compliant Printing Protocol Level 3 Programming Supplement.
2.6.1 Loading Envelopes
Always use the front output tray when printing envelopes for faceup
stacking. See Section 2.7.2 for information about selecting and installing
the front output tray. For clarity, the illustrations in the following procedure
do not show the front output tray in place.
Make the following checks before loading envelopes:
•
The sealing flap should run along the length of the envelope, not at the
leading or trailing edges.
•
The sealing flap should be folded properly, with none of the glue
exposed.
•
The leading and trailing edges should not be more than two layers thick.
•
The envelope should be free of any wrinkles or creases.
CAUTION:
Using envelopes made of artificial materials (nonpaper), or those
that have fasteners, snaps, or windows, can cause serious damage to the
printer. See Section 5.2 for complete envelope specifications.
2–12
Operator’s Guide
Summary of Contents for DEClaser 1100 Series
