2.8 Adjusting the Print Density
Print density is the term used to describe the amount (density) of toner
applied to the paper. The print density adjustment controls the amount of
toner applied to the paper to produce a lighter or darker print.
You can significantly extend the life of an electrophotographic laser
(EP-L) cartridge by using the lightest possible print density setting that
gives you acceptable print quality.
NOTE:
The EP-L cartridge life can be up to 3,300 A4 or letter-size pages.
This specification is based on 4% toner coverage with the print density set
at its default position.
Use the following procedure to adjust print density.
1.
Lift up the release button to open the front cover.
— The Alarm indicator lights.
— The display reads 12 PRINTER OPEN.
— The printer goes off line.
MLO-005808
2–24
Operator’s Guide
Summary of Contents for DEClaser 1100 Series
