2.13 Resetting the Printer
There are two methods of resetting the printer: You can perform a hard
reset by powering the printer off and then back on or you can perform a
soft reset by pressing
Reset
.
CAUTION:
When performing a hard reset, always wait at least two seconds
before you power the printer back on.
Perform a soft reset of the printer under the following circumstances:
•
When changing the paper feed input between tray and cassette
•
When changing paper tray sizes (see Section 2.5)
•
When changing paper cassette sizes
•
To clear data in the print buffer
•
To invoke features in the INITIAL menu (see Table 4–12)
•
To enter and exit Control Representation Mode (see Section 2.12.1)
Use the procedure in Table 2–7 to perform a soft reset.
Table 2–7: Resetting the Printer
Operation
Display Reads
1. Press
On Line
to place the
printer off line.
– The On Line indicator
goes off.
00 READY
2. Press and hold
Reset
for about
three seconds.
03 RESET
#
00 READY
3. Press
On Line
to place the
printer back on line.
– The On Line indicator
lights.
00 READY
2–36
Operator’s Guide
Summary of Contents for DEClaser 1100 Series
