2.14 Emulation and Video Modes of Operation
The DEClaser 1100 operates using Digital’s ANSI-compliant level 3 printing
protocol (DEC PPL3). If you have an optional emulation cartridge or are
using an external video controller, you must select the proper operating
mode. Emulation mode is selected when you want to invoke a protocol
from an optional emulation cartridge that is installed in the printer. Video
mode is selected when you have an external video controller connected to
the printer.
Use the procedure in Table 2–8 to select the emulation or video mode of
operation.
Table 2–8: Selecting Emulation or Video Mode
Operation
Display Reads
1. Press
On Line
to place the
printer off line.
– The On Line indicator
goes off.
00 READY
2. Press and hold
Menu
for about
three seconds.
MODE = DEC 00
3. Press
.
or
/
to
select the emulation
or video mode.
MODE
‘‘EMULATION NAME’’
or
MODE
VIDEO
4. Press
r
Enter
to select
and save the mode.
– The mode is automatically
saved in NVRAM.
MODE = ‘‘EMULATION NAME’’
(for emulation mode)
or
*00 EX READY (for video mode)
5. Press
On Line
to place the
printer back on line.
— The On Line indicator
lights.
MODE = ‘‘EMULATION NAME’’
(for emulation mode)
or
*00 EX READY (for video mode)
Operating Information
2–37
Summary of Contents for DEClaser 1100 Series
