4.3.2 ROM (Read-Only Memory)
ROM contains default values that are set at the factory. They are called
default values because they are stored in ROM and cannot be changed. You
can load these default values into operating memory while in Menu Mode
using the procedure shown in Table 4–3.
NOTE:
Default values loaded from ROM are temporary values in
operational memory, and are affected if the printer receives a reset command
or is powered off. If you want to retain the default values, you must save
them in NVRAM (see Section 4.3.3).
Table 4–3: Recalling Factory Default Values from ROM
Operation
Display Reads
1. Press
On Line
to place the
printer off line.
— The On Line indicator
goes off.
00 READY
2. Press
Menu
to place the
printer in Menu Mode.
FONT/FEED LAYOUT
3.
Press
/
once.
LOAD<–ROM FONT/F
4.
Press
r
Enter
to load
the default values
from ROM into
operating memory.
OK (momentarily)
#
LOAD<–ROM FONT/F
5.
Press
On Line
to place
the printer on line.
— The On Line indicator
lights.
00 READY
4–8
Operator’s Guide
Summary of Contents for DEClaser 1100 Series
